Universal input 100 to 250 VAC
Single, dual output options
Over current protection
100% Hi-Pot tested
100% cycling burnt-in.

Line regulation: 0.20%
Load regulation: 5%
Maximum power: 40W for convection cooled
Hold up time: 20ms at full load, 120 VAC
Efficiency: 70% typical at full load, varies with distribution of loads among outputs
Transient response: main output 50-100% load and output regulation meet spec.
Over voltage protection: Pulsing mode, Auto recovery
Short circuit protection: Pulsing mode, Auto recovery
Over current : Pulsing mode, Auto recovery

Input voltage: 90 to 264 VAC
Input frequency: 47 to 63 Hz
Input current: 1.2A max at 90 VAC
Inrush current: 50 A max. for two cycles or less
Protection: 2 A fuse on board
Configuration: IEC 60320 C14

Topology: FLYBACK
Dielectric strength test: 3K VAC primary to secondary 4.24K VDC primary to secondary
Insulation resistance: 50M Ohm @ 500 VDC primary to secondary
Leakage current: Less than 3.5 mA @ 240 VAC 50 Hz
MTBF: 50,000 hrs min. at full load and 25°C

Conducted / radiated emissions: 

Operating temperature, full load, no derating:0~40°C
Non-operating: -20~85°C
Relative humidity non-condensing: 0~95%
Altitude: Sea level up to 25,000 feet
Cooling: Convection cooled
Shock: Per MIL-STD-810C 516 Part V
Vibration: 10 to 500 Hz, 15 mins/ cycle/ axis